Printable View (47 KB)
TSB 13-4-22	WRENCH LAMP WITH DTC P061A/U1011/P060C - REDUCTION IN VEHICLE POWER
Publication Date: April 29, 2013

ISSUE:

Some 2013 C-MAX Hybrid/Energi vehicles built on or before 4/9/2013 may exhibit illuminated wrench lamp or red triangle lamp or both with diagnostic trouble code (DTC) P061A in the powertrain control module (PCM) and/or U1011 in the transmission control module (TCM) and/or P060C in the TCM.

ACTION:

Reprogram the PCM to the latest calibration using IDS release 84.02 and higher. Calibration files may also be obtained at www.motorcraft.com.

WARRANTY STATUS:

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.

DEALER CODING

NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by "do-it-yourselfers". Do not assume that a condition described affects your car or truck. Contact a Ford or Lincoln dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated otherwise in the TSB article. The information in this Technical Service Bulletin (TSB) was current at the time of printing. Ford Motor Company reserves the right to supercede this information with updates. The most recent information is available through Ford Motor Company's on-line technical resources.

Copyright © 2013 Ford Motor Company