Note:  Fully defrost the windshield before you switch the windshield wipers on.
Note:  Make sure you switch the windshield wipers off before entering a car wash.
Note:  If streaks or smears appear on the windshield, clean the windshield and the wiper blades. See  Checking the Wiper Blades.  If that does not resolve the issue, install new wiper blades. See  Changing the Wiper Blades
 Autowipers uses a rain sensor located in the area around the interior mirror. The rain sensor will continue to monitor the amount of water on the windshield and automatically adjust the speed of the wipers.
Missing Image
AHigh sensitivity
BOn
CLow sensitivity
 Use the rotary control to adjust the sensitivity of the autowipers. When you select low sensitivity, the wipers will operate when the sensor detects a large amount of water on the windshield. When you select high sensitivity, the wipers will operate when the sensor detects a small amount of water on the windshield.
 Keep the outside of the windshield clean. The rain sensor is very sensitive and the wipers may operate if dirt, mist or insects hit the windshield.
 Wet or winter driving conditions with ice, snow or salty road mist can cause inconsistent and unexpected wiping or smearing.
In these conditions, you can do the following:
  • Lower the sensitivity of the autowipers to reduce the amount of smearing on the windshield.
  • Switch to normal or high-speed wipe.
  • Switch autowipers off.
Note:  If you switch autolamps and autowipers on, the headlamps will automatically turn on when the windshield wipers continuously operate.
Autowipers Settings
Autowipers default to on and remain on until you switch it off in the information display. With autowipers switched off, the wipers operate in intermittent mode. See General Information