WARNING
  Switch all of the lamps and the ignition off. Failure to follow this warning could result in serious personal injury.
  Bulbs become hot when in use. Let them cool down before you remove them.

Use the correct specification bulb. See  Bulb Specification Chart
Install in the reverse order unless otherwise stated.
Headlamp
You must remove the headlamp assembly prior to replacing any bulb. See  Removing a Headlamp
Missing Image
A Front side lamp.
B High beam.
C Low beam.
D Front direction indicator.
Front Side Lamp
  1. Remove the headlamp.
  1. Remove the cover.
  1. Remove the bulb holder by pulling it straight out.
  1. Remove the bulb by pulling it straight out.
Front Direction Indicator
  1. Remove the headlamp.
  1. Turn the bulb holder counterclockwise and remove it.
Note:  You cannot separate the bulb from the bulb holder.
Headlamp Low Beam
  1. Remove the headlamp.
  1. Remove the cover.
  1. Turn the bulb holder counterclockwise and remove it.
  1. Disconnect the electrical connector.
Note:  Do not touch the bulb glass.
Note:  You cannot separate the bulb from the bulb holder.
Headlamp High Beam
  1. Remove the headlamp.
  1. Remove the cover.
  1. Turn the bulb holder counterclockwise and remove it.
  1. Disconnect the electrical connector.
Note:  Do not touch the bulb glass.
Note:  You cannot separate the bulb from the bulb holder.
High-Intensity Discharge Headlamps
These lamps operate at a high voltage. See an authorized dealer if they fail.
LED Lamps
LED lamps are not serviceable items. See an authorized dealer if they fail.
The following lamps are LED:
  • Brake and rear lamps.
  • Central high mounted brake lamp.
  • Daytime running lamps.
  • Rear direction indicators.
  • Side direction indicators.
Reverse Lamp
  1. Carefully remove the luggage compartment trim panel.
  1. Remove the wing nut.
  1. Gently pull the lamp assembly away from the vehicle.
Missing Image
  1. Turn the bulb holder counterclockwise and remove the bulb holder.
Missing Image
  1. Remove the bulb from the bulb holder.
Replacing the License Plate Lamp Bulb
Missing Image
  1. Carefully release the spring clip.
  1. Remove the lamp.
  1. Remove the bulb.