You can use the power door lock control or the remote control to lock and unlock your vehicle.
Note:   Always take your keys and lock all doors when leaving your vehicle.
Power Door Locks
The power door lock control is on the driver and front passenger door panels.
Power Door Lock/Unlock Buttons
AUnlock
BLock
Door Lock Indicator
An LED on each power door lock control will light when you lock the doors. It is not a functional control.
Remote Control
Unlocking the Doors (Two-Stage Unlock)
Type 1
Remote Control Unlock Button  Press the button to unlock the driver door.
Type 2
Unlock Icon  Press the button to unlock the driver door.
Press the button again within three seconds to unlock all doors. The direction indicators will flash.
Press and hold both the lock and unlock buttons on the remote control for four seconds to disable or enable two-stage unlocking. Disabling two-stage unlocking allows all vehicle doors to unlock with one press of the button. The turn signals will flash twice to indicate a change to the unlocking mode. The unlocking mode applies to the remote control and intelligent access.
Intelligent access at the driver door will unlock all doors when you disable two-stage unlocking.
Locking the Doors
Type 1
Remote Control - Lock Button  Press the button to lock all the doors. The direction indicators will flash.
Type 2
Lock Icon  Press the button to lock all the doors. The direction indicators will flash.
 Press the button again within three seconds to confirm that all the doors are closed.The doors will lock again, the horn will sound and the turn signals will flash if all the doors and the luggage compartment are closed.
Note:   If locking was not successful or any door or the liftgate is open, or if the hood is open on vehicles with a perimeter alarm or remote start, the horn will sound twice and the lamps will not flash.
Liftgate
WARNING   WARNING:  Make sure all persons are clear of the power liftgate area before using the power liftgate control.
WARNING   WARNING:  Make sure to close and latch the liftgate to prevent drawing exhaust fumes into your vehicle. This will also prevent passengers and cargo from falling out. If you must drive with the liftgate open, keep the vents or windows open so outside air comes into your vehicle. Failure to follow this warning could result in serious personal injury.

Note:   Be careful when opening or closing the liftgate in a garage or other enclosed area to avoid damaging the liftgate.
Liftgate Ajar  Press twice within three seconds to:
  • unlatch a manual liftgate
  • open, close or stop the movement of a power liftgate. See  Power Liftgate . 
Mechanical Key
Turn the top of the key toward the front of your vehicle once to lock all doors.
Turn the top of the key toward the rear of your vehicle once to unlock the driver door only.
Locking the Doors Individually
If the power locks fail to operate, lock the doors individually using the key in the position shown.
Child Safety Lock
Left-Hand Side
Turn clockwise to lock.
Right-Hand Side
Turn counterclockwise to lock.
Opening a Rear Door from Inside
Pull the interior door release handle twice to unlock and open a rear door. The first pull unlocks the door and the second pull will unlatch the door.
Activating Intelligent Access
You can unlock and lock the vehicle without taking the keys out of your pocket or purse when your intelligent access key is within 3 ft (1 m) of your vehicle. Intelligent access uses a sensor on the back of the door handle for unlocking and a separate sensor on the face of each door handle for locking.
The system does not function if:
  • Your vehicle battery has no charge.
  • The key battery has no charge.
  • The key frequencies are jammed.
Note:   The system may not function if the key is close to metal objects or electronic devices, for example keys or a cell phone.
Note:   If the system does not function, use the key blade to lock and unlock your vehicle. See  Remote Control . 
Unlocking Using Intelligent Access
Unlocking Using Passive Entry
With your intelligent access key within 3 ft (1 m) of your vehicle, touch the unlock sensor on the back of the door handle for a brief period and then pull on the door handle to unlock, being careful to not touch the lock sensor at the same time or pulling the door handle too quickly. The intelligent access system requires a brief delay to authenticate your intelligent access key fob.
Locking Using Intelligent Access
Lock the Car (Passive Entry Passive Start System)
With your intelligent access key within 3 ft (1 m) of your vehicle, touch the outer door handle lock sensor for approximately one second to lock, being careful to not touch the unlock sensor on the back of the door handle at the same time. After locking, you can immediately pull on the door handle to confirm locking occurred without inadvertently unlocking.
At the Liftgate
Press the exterior liftgate release button on the top of the liftgate pull-cup handle.
Smart Unlocks For Integrated Keyhead Transmitter
This feature helps to prevent you from locking yourself out of your vehicle if your key is still in the ignition.
When you open one of the front doors and lock your vehicle with the power door lock control, all the doors will lock then unlock if your key is still in the ignition.
You can still lock your vehicle with the key in the ignition by pressing the lock button on the transmitter even if the doors are not closed.
If both front doors are closed, you can lock your vehicle by any method, regardless of whether the key is in the ignition or not.
Smart Unlocks For Intelligent Access Keys (If Equipped)
This feature helps to prevent you from unintentionally locking your intelligent access key inside your vehicle’s passenger compartment or rear cargo area.
When you lock your vehicle using the power door lock control (with the door open, vehicle in park and ignition off), your vehicle will search for an intelligent access key in the passenger compartment after you close the door. If your vehicle finds a key, all of the doors will immediately unlock.
When you open one of the front doors and lock your vehicle using the power door lock control, all doors will lock then unlock if the ignition is on.
Autolock (If Equipped)
Autolock locks all the doors when:
  • All doors are closed.
  • The ignition is on.
  • You shift into any gear putting your vehicle in motion.
  • Your vehicle reaches a speed greater than 4 mph (7 km/h).
Autounlock
Autounlock unlocks all the doors when:
  • The ignition is on, all the doors are closed, and your vehicle has been moving at a speed greater than 4 mph (7 km/h).
  • Your vehicle comes to a stop and you switch the ignition off or to the accessory position.
  • You open the driver door within 10 minutes of switching the ignition off or to accessory.
Note:   The doors will not autounlock if you electronically lock your vehicle after you switch the ignition off and before you open the driver door.
Enabling or Disabling Autounlock
Note:   Your authorized dealer can perform this procedure, or you can do the procedure yourself.
To enable or disable these features, do the following:
Note:   You will have 30 seconds to complete the procedure.
  1. Switch the ignition on.
  1. Press the power door unlock button three times.
  1. Switch the ignition off.
  1. Press the power door unlock button three times.
  1. Switch the ignition on.The horn will sound indicating your vehicle is in programming mode.
  1. Press the power door lock button then the unlock button. The horn will sound once if disabled or twice (one short and one long) if enabled.
After programming the feature, switch the ignition off. The horn will sound once indicating programming is complete.
Illuminated Entry
The interior lamps and select exterior lamps will illuminate when you unlock the doors with the remote entry system.
The illuminated entry system turns off the lights if:
  • you start your vehicle,
  • you press the remote control lock button, or
  • after 25 seconds of illumination.
The lights will not turn off if:
  • you turn them on with the lamp control, or
  • any door is open.
Illuminated Exit
The interior lamps and select exterior lamps will illuminate when all doors are closed and you switch the ignition off.
The lamps will turn off if all the doors remain closed and:
  • 25 seconds elapse, or
  • you lock your vehicle from the outside.
Battery Saver
If you leave the courtesy lamps or dome lamps on and switch the ignition off, the battery saver shuts them off after some time.
Accessory Mode Battery Saver for Intelligent Access Keys (If Equipped)
If you leave the ignition on after leaving your vehicle, it will shut off 15 minutes after you close all of the doors.

Owner's Manual Feedback

Submit

Thank You For Your Feedback

Ok