Note:   Fully defrost the windshield before you switch the windshield wipers on.
Note:   Make sure you switch the windshield wipers and vehicle power off before using an automatic car wash.
Note:   If streaks or smears appear on the windshield, clean the windshield and the wiper blades.   See   Checking the Wiper Blades.  If that does not resolve the issue, install new wiper blades.   See   Changing the Wiper Blades
Note:   Do not operate the wipers on a dry windshield. This may scratch the glass, damage the wiper blades or cause the wiper motor to burn out. Always use the windshield washers before wiping a dry windshield.
Note:   When wiping on dry glass, the wipers may switch to the next lower operating mode (low-speed or intermittent). The previous operation mode may resume after the windshield becomes wet again.
Wiper Stalk
ASingle wipe.
BIntermittent wipe.
CNormal wipe.
DHigh-speed wipe.
Note:   Move to position O marked on the wiper lever to switch off.
Intermittent Wipe
Intermittent Wiper Switch
AShort-wipe interval.
BIntermittent wipe.
CLong-wipe interval.
Push the wiper lever up to switch the wipers on, and then use the rotary control to adjust the intermittent wipe interval.
Speed Dependent Wipers (If Equipped)
When your vehicle speed increases, the interval between wipes decreases.

Owner's Manual Feedback

Submit

Thank You For Your Feedback

Ok