Note:   The system is not compatible with non-Ford aftermarket remote start systems.Use of these systems may result in engine starting problems and a loss of security protection.
Note:   Metallic objects, electronic devices or a second coded key on the same key chain may result in vehicle starting problems, especially if they are too close to the key when starting your vehicle.Prevent these objects from touching the coded key when starting your vehicle.Switch the ignition off, move all objects on the key chain away from the coded key and restart your vehicle if a problem occurs.
Note:   Do not leave a duplicate coded key in your vehicle.Always take your keys and lock all doors when leaving your vehicle.
SecuriLock®
The system helps prevent the engine from starting unless you use a coded key programmed to your vehicle. Using the wrong key may prevent your vehicle from starting. A message may appear in the information display.
If you are unable to start your vehicle with a coded key, it is not operating correctly. A message may appear in the information display.
Automatic Arming
The system arms when you switch the ignition off.
Automatic Disarming
The system disarms when you switch the ignition on with a coded key.
Replacement Keys
The intelligent access key functions as a programmed key that operates the driver door lock and activates the intelligent access with push button start system, as well as a remote control.
If your coded keys are lost or stolen and you do not have an extra coded key, you need to erase the key codes from your vehicle and program new coded keys. Contact an authorized dealer.
Store an extra programmed key away from your vehicle in a safe place. You can purchase replacement keys or remote controls from an authorized dealer.
Programming a Spare Intelligent Access Key
Note:   You can program a maximum of four intelligent access keys to your vehicle.
You must have two previously programmed intelligent access keys inside your vehicle and the new unprogrammed intelligent access keys readily accessible. If two previously programmed coded keys are not available, contact an authorized dealer.
 Make sure that the ignition is switched off before beginning this procedure. Make sure that you close all the doors before beginning and that they remain closed throughout the procedure. Carry out all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you carry out any steps out of sequence.
Read and understand the entire procedure before you begin.
Missing Image
  1. Open the floor console storage compartment lid.
Missing Image
  1. With the buttons facing the rear of your vehicle and the key ring up, place the intelligent access key into the backup slot.
  1. Press the push button ignition switch.
  1. Wait five seconds and then press the push button ignition switch again.
  1. Remove the intelligent access key.
  1. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.
  1. Wait five seconds and then press the push button ignition switch again.
  1. Remove the intelligent access key.
  1. Wait five seconds, then place the unprogrammed intelligent access key in the backup slot and press the push button ignition switch.
 Programming is now complete. Check that the remote control functions operate and your vehicle starts with the new intelligent access key.
If programming was unsuccessful, wait 10 seconds and repeat Steps 1 through 7. If programming remains unsuccessful, contact an authorized dealer.