You can use the power door lock or the remote control to lock and unlock your vehicle.
Power Door Locks
The power door lock is on the driver and front passenger door panels.
AUnlock BLock
|
Door Lock Indicator
An LED on each door window trim lights when you lock the door. It remains on for up to five minutes after you switch the ignition off.
Switch Inhibitor
When you electronically lock your vehicle, the power door lock and interior luggage compartment release switch will no longer operate after 20 seconds. You must unlock your vehicle with the remote control or keyless keypad, or switch the ignition on, to restore function to these switches. You can switch this feature on or off in the information display. See
General Information.
Remote Control
You can use the remote control at any time. The luggage compartment release button only works when your vehicle speed is less than
3 mph (5 km/h).
Unlocking the Doors (Two-Stage Unlock)
Press the button to unlock the driver door.Press the button again within three seconds to unlock all doors. The direction indicators will flash. Press and hold both the lock and unlock buttons on the remote control for four seconds to disable or enable two-stage unlocking.Disabling two-stage unlocking allows all vehicle doors to unlock with one press of the button. The direction indicators will flash twice to indicate a change to the unlocking mode. The unlocking mode applies to the remote control, keyless entry keypad and intelligent access. Intelligent access at the driver door will unlock all doors when you disable two-stage unlocking. | |
Locking the Doors
Press the button to lock all the doors. The direction indicators will flash.
Press the button again within three seconds to confirm that all the doors are closed.The doors lock again, a tone sounds and the direction indicators flash if all the doors and the luggage compartment are closed.
Mislock
If any door or the luggage compartment is open, or if the hood is open on vehicles with an anti-theft alarm or remote start, a tone sounds and the direction indicators will not flash. You can switch this feature on or off in the information display. See
General Information.
Audible and Visual Locking Confirmation
If audible and visual locking confirmation is configurable, you can turn it on or off using the information display. See
General Information.
Mechanical Key
The intelligent access key also contains a removable key blade that you can use to lock and unlock your vehicle. See
Remote Control.
Turn the top of the key toward the front of your vehicle once to lock all doors.
Turn the top of the key toward the rear of your vehicle once to unlock the driver door only.
Locking the Doors Individually
If the power locks fail to operate, lock the doors individually using the key in the position shown.
Left-Hand Side
Turn clockwise to lock.
Right-Hand Side
Turn counterclockwise to lock.
Opening a Rear Door from Inside
Pull the interior door handle twice to unlock and open a rear door.The first pull unlocks the door and the second pull will unlatch the door.
Activating Intelligent Access
General Information
You can unlock and lock the vehicle without taking the keys out of your pocket or purse when your intelligent access key is within
3 ft (1 m) of your vehicle. Intelligent access uses a sensor on the back of the door handle for unlocking and a separate sensor on the face of each door handle for locking.
The system will not function if:
- Your vehicle battery has no charge.
- The key battery has no charge.
- The key frequencies are jammed.
Note:
The system may not function if the passive key is close to metal objects or electronic devices, for example keys or a cell phone.
Note:
If the system does not function, use the key blade to lock and unlock your vehicle. See
Remote Control.
Unlocking Using Intelligent Access
With your intelligent access key within
3 ft (1 m) of your vehicle, touch the unlock sensor on the back of the door handle for a brief period and then pull on the door handle to unlock, being careful to not touch the lock sensor at the same time or pulling the door handle too quickly. The intelligent access system requires a brief delay to authenticate your intelligent access key fob.
Locking Using Intelligent Access
With your intelligent access key within
3 ft (1 m) of your vehicle, touch the outer door handle lock sensor for approximately one second to lock, being careful to not touch the unlock sensor on the back of the door handle at the same time. After locking, you can immediately pull on the door handle to confirm locking occurred without inadvertently unlocking.
At the Liftgate
Press the exterior liftgate release button inside the top of the liftgate pull-cup handle.
Smart Unlocks
This feature helps to prevent you from unintentionally locking your intelligent access key inside the passenger compartment or rear cargo area.
When you lock your vehicle with the door open and the ignition off, your vehicle will search for an intelligent access key in the passenger compartment after you close the door. If your vehicle finds a key, all of the doors will immediately unlock.
You can override the smart unlock feature and intentionally lock the intelligent access key inside your vehicle. To do this, lock your vehicle after you have closed all the doors by:
- Using the keyless entry keypad.
- Pressing the lock button on another intelligent access key.
- Touching the locking area on the handle with another intelligent access key in your hand.
When you open one of the front doors with the ignition on, and lock your vehicle using the power door lock, all doors will lock then unlock.
Autolock (If Equipped)
Autolock locks all the doors when all of the following occur:
- All doors are closed.
- The ignition is on.
- You shift into any gear putting your vehicle in motion.
- Your vehicle reaches a speed greater than
12 mph (20 km/h).
Autolock repeats when:
- You open then close any door while the ignition is on and your vehicle speed is
9 mph (15 km/h) or lower.
- Your vehicle reaches a speed greater than
12 mph (20 km/h).
Autounlock
Autounlock unlocks all the doors when:
- The ignition is on, all the doors are closed, and your vehicle has been moving at a speed greater than
12 mph (20 km/h).
- Your vehicle comes to a stop and you switch the ignition off or to the accessory position.
- You open the driver door within 10 minutes of switching the ignition off or to accessory.
Note:
The doors do not autounlock if you electronically lock your vehicle after you switch the ignition off before you open the driver door.
Enabling or Disabling
You can enable or disable the feature in the information display or an authorized dealer can do it for you. See
General Information.
Illuminated Entry
The interior lamps and select exterior lamps will light when you unlock the doors with the remote control.
The system turns off the lights if:
- You start your vehicle.
- You press the remote control lock button.
- They are on for 25 seconds.
The lights will not turn off if:
- You switch them on with the lamp control.
- Any door is open.
Illuminated Exit
The interior lamps and select exterior lamps will light when all doors are closed and you switch the ignition off.
The lamps turn off if all the doors remain closed and either of the following occurs:
- After 25 seconds elapse.
- You lock your vehicle from the outside.
Battery Saver
If you leave the courtesy lamps or dome lamps on and switch the ignition off, this feature turns them off after some time.
Accessory Mode Battery Saver for Intelligent Access Keys
If you leave your vehicle with the ignition on, it will turn off 15 minutes after you close all of the doors.
Welcome Lighting
This feature lights select exterior lighting as you approach your vehicle. You must have an intelligent access key with you. The feature turns off when you open a door, liftgate, or unlock your vehicle. Welcome lighting remains on for 25 seconds or until you start your vehicle.
The feature is active when:
- The feature is configured on in the information display. See
General Information.
- The ignition is off.
- All doors and the liftgate are closed.
- You lock your vehicle.
The feature is not active when:
- Your vehicle detects the intelligent access key is inside.
- The intelligent access key is in close range of the vehicle for more than two minutes.
- The anti-theft alarm triggers.
- You do not start your vehicle for more than five days.
- The vehicle battery charge is low.
Note:
When this feature is disabled, you must switch the ignition on to reset it.
Note:
This feature may not correctly operate if the intelligent access key is stored within
8–15 ft (2.4–4.6 m) of your vehicle while not in use.