Electric sunroof
WARNING:
Before operating the power moonroof you should verify it is free of obstructions and ensure that children and/or pets are not in the proximity of the moonroof opening. Failure to do so could result in serious personal injury. It is the primary responsibility of the supervising adults to never leave a child unattended in a vehicle and to never leave the keys in an unattended vehicle. |
Note:
When the switches are operated often during a short period of time, the system might become inoperable for a certain time to prevent damage due to overheating.
Note:
The power moonroof can also be operated with the ignition off via the global opening and global closing function. See
Global Opening and Closing.
There are two ways of opening the moonroof – the rear of the moonroof lifts open or the moonroof opens from the front, sliding back under the roof. The moonroof opens and closes whilst the switch is pressed.
Switch on the ignition to operate the power moonroof.
The power moonroof is operated by a switch located between the sun visors.
Opening and closing the moonroof
Tilting the moonroof
Opening and closing the moonroof automatically
Note:
When opening automatically, the moonroof will stop about 8 cm from the fully opened position. This position reduces the buffeting noise which is sometimes heard when the moonroof is fully open. The moonroof will only stop automatically in this position when the moonroof is opened automatically.
To open or close the moonroof automatically press either side of the switch to the second action point and release it completely. Press again to stop.
When the closed position is reached, the moonroof stops automatically.
Moonroof anti-trap protection
|
WARNING:
The anti-trap function is deactivated until the memory has been reset. Careless closing of the window can cause injuries.
WARNING:
Careless closing of the power moonroof can override the anti-trap protection and cause injuries. |
The moonroof will stop automatically while closing and reverse some distance if there is an obstacle in the way.
To override anti-trap protection when there is a resistance, e. g. in the winter, proceed as follows:
|
WARNING:
While the moonroof is being closed for the third time, the anti-trap function is disabled. Make sure there are no obstacles in the way of the closing moonroof. |
Close the moonroof a third time to the resistance. The anti-trap function is disabled and the moonroof cannot be closed automatically. The moonroof will override the resistance and can then be closed fully.
If the moonroof does not close after the third attempt, have it checked by an expert.
Moonroof safety mode
|
WARNING:
The anti-trap function is not active during this procedure. Make sure that there are no obstacles in the way of the closing moonroof. |
If the system detects a malfunction, it enters a safety mode. The moonroof will move for only about 0.5 seconds at a time and then stop again. Close the moonroof by pressing the button again when the moonroof stops moving. When the rear of the moonroof is lifted, lift the rear all the way and then close the moonroof. Have the system checked by an expert immediately.
Moonroof relearning
|
WARNING:
The anti-trap function is not active during this procedure. Make sure that there are no obstacles in the way of the closing moonroof. |
In case the moonroof no longer closes properly, follow this relearning procedure:
- Tilt the rear of the moonroof as far as possible. Release the button.
- Press and hold the same button again for 30 seconds until you see the moonroof move.
- Release the button and immediately press and hold it again. The moonroof will close, open fully and then close again. Do not release the button before the moonroof has reached the closed position for the second time.
If the button is not pressed continuously, the relearning function will be interrupted. Start the procedure once more from the beginning.
Thank You For Your Feedback