CAUTION:
Using the system with the engine off will drain the battery. |
Note:
You will be charged when sending and receiving text messages.
Note:
Refer to your phone handbook for all phone functions and operation.
Note:
Keep the activation code (printed on the installation guide) in a safe place.
Note:
Retain the activation text message in your cell phone inbox.
Compatibility of phones
CAUTION:
As no common agreement exists, cell phone manufacturers are able to implement a variety of profiles in their Bluetooth devices. Because of this, an incompatibility can occur between the phone and hands-free system, which in some cases may significantly degrade the system performance. To avoid this situation, only recommended phones should be used. |
Please visit the website www.ford-mobile-connectivity.com for full details.
Installing the micro SD card
- Remove the micro SD card from the adaptor.
- Insert the micro SD card into the cell phone.
Activating the cell phone navigation system
Note:
The radio must be switched on before connecting the cell phone to the in-car GPS receiver.
Note:
The Ford Mobile Navigation must be installed and activated on your cell phone.
Note:
It is possible to activate up to a maximum of three phones.
Note:
Detailed instructions are available on the micro SD card and at www.ford-mobile-connectivity.com.
To connect the device to the system follow the same procedure as for Bluetooth hands free phones. See
Bluetooth setup.
- Switch the radio on.
- Switch your cell phone on and start the "Ford Mobile Navigation".
- Choose "Select Destination".
- Choose "Enter Address".
- Change route options if necessary and start the route guidance.
- The vehicle display will show the turn information. Voice instructions are heard via the vehicle speakers.
Note:
Your cell phone will display your current position.
- You are able to exit the application and continue your route guidance after restarting the application.