Removing the Push Pins
Note:   To remove push pins, use a flat-bladed screwdriver to pull up the center release pin.
  1. Make sure the headlamp control is in the off position and open the hood.
  1. Remove the six push pins securing the front fascia to the front trim cover.
  1. Remove the three bumper cover upper screws using a flat-bladed screwdriver.
  1. Remove the push pin at the inboard side of the headlamp you are servicing.
Headlamp Assembly Remove and Install
  1. Remove the two screws securing the headlamp using a flat-bladed screwdriver.
Accessing the Direction Indicator and Fog Lamp Bulbs
  1. Remove the lower three wheel housing fasteners by turning them counterclockwise.
Outmost Front Bumper Cover Lower Fasteners
  1. Remove the two outmost front bumper cover lower fasteners, only on the side of the headlamp you are servicing, by turning them counterclockwise.
Front Bumper Cover Removal
  1. Separate the front bumper cover from the fender by gently pulling the front bumper cover to the outside of the vehicle 3 cm.
Pulling the Front Bumper Cover
  1. From the front of the vehicle, gently pull the front bumper cover forward 10 cm by grasping it next to the headlamp to be serviced and in the lower front of the wheel opening.
Headlamp Assembly - Removal and Installation
  1. Gently pull the headlamp assembly outward to disengage it from the lower fixing point.
  1. Carefully lift the headlamp and remove it from the vehicle.
  1. Disconnect the electrical connector from the headlamp assembly by pushing the release tab on the connector.