This view of the Owner’s Manual contains the very latest information, which may vary slightly from the printed Owner’s Manual originally provided with your vehicle. It may also describe content that is not on or operates differently on your vehicle. Please consider the Owner’s Manual originally provided with your vehicle as the primary source of information for your vehicle.
The information contained in this publication was correct at the time of release.In the interest of continuous development, we reserve the right to change specifications, design or equipment at any time without notice or obligation.No part of this publication may be reproduced, transmitted, stored in a retrieval system or translated into any language in any form by any means without our written permission.Errors and omissions excepted.
Copyright © 2024 Ford Motor Company
Creating a MyKey
Use the information display to create a MyKey. There are two types of information displays, and their controls and messaging vary. To determine which type of display you have, you will need to reference another chapter. See
General Information.
If You Have a Type 1 Information Display:
- Insert the key you want to program into the ignition.
- Switch the ignition on.
- Access the main menu on the information display controls. Press SETUP using the information display buttons until PRESS RESET TO CREATE MYKEY is displayed.
- Press and release the RESET button. You will see HOLD RESET TO CONFIRM MYKEY in the display.
- Press and hold the RESET button for two seconds until you see the message MARK THIS AS RESTRICTED in the display. Wait until you see KEY RESTRICTED AT NEXT START in the display.
If You Have a Type 2 Information Display:
- Insert the key you want to program into the ignition.
- Switch the ignition on.
- Access the main menu on the information display controls, and select SETTINGS, then MYKEY by pressing OK or the > button.
- Press OK or the > button to select CREATE A MYKEY.
- When prompted, hold the OK button until you see KEY RESTRICTED AT NEXT START in the display. The key will be restricted at the next start.
MyKey is successfully created. Make sure you label it so you can distinguish it from the admin keys.
You can also program configurable settings for the key(s). Refer to Programming/Changing Configurable Settings.
Programming/Changing Configurable Settings
Use the information display to program or change your configurable MyKey settings. There are two types of information displays, and their controls and messaging vary. To determine which type of display you have, you will need to reference another chapter. See
General Information.
If You Have a Type 1 Information Display:
- Switch the ignition on using an admin key.
- Access the main menu on the information display controls, and press SETUP until RESET FOR MYKEY SETTINGS displays.
- Press and release the RESET button to display MyKey setup menus.
- Press the SETUP button to enter your choice. Once you make a selection, the next configurable setting will be displayed.
- Repeat Steps 3 and 4 until you are done changing the configurable settings.
If You Have a Type 2 Information Display:
- Switch the ignition on using an admin key.
- Access the main menu on the information display controls, and select SETTINGS, then MYKEY by pressing OK or the > button.
- Use the arrow buttons to get to a configurable feature.
- Press OK or > to make a selection.
Note:
You can clear or change your MyKey settings at any time during the same key cycle as you created the MyKey. Once you have switched the engine off, however, you will need an admin key to change or clear your MyKey settings.
Thank You For Your Feedback