Alarm System
Note:
Do not arm the alarm with full guard if passengers, animals or other moving objects are inside your vehicle.The alarm could unintentionally turn on.
Perimeter Alarm
The perimeter alarm is a deterrent against unauthorized access to your vehicle through the doors and the hood. It also protects the audio unit.
Interior Sensors
The interior lamp unit sensors are located in the overhead console.
Note:
Do not cover up the interior lamp unit sensors.
The sensors act as a deterrent against unauthorized intrusion by sensing any movement inside your vehicle.
Inclination Sensors
When you lock your vehicle and arm the alarm, the sensors are designed to detect an attempt to raise your vehicle, for example to remove a wheel or to tow it away.
Triggering the Alarm
Once armed, the alarm is triggered in any of the following ways:
- If someone opens a door, the liftgate or the hood without a valid key or remote control.
- If you switch your vehicle on without a correctly coded key.
- If the interior sensors detect movement within your vehicle.
If the alarm is triggered, the alarm horn will sound for 30 seconds and the hazard warning flasher will flash for five minutes.
Any further attempts to perform one of the above will trigger the alarm again.
Full and Reduced Guard
Full Guard
Full guard is the standard setting.
In full guard, the interior sensors are on when you arm the alarm.
Reduced Guard
In reduced guard, the interior sensors are off when you arm the alarm.
Selecting Full or Reduced Guard
Ask on Exit (If Equipped)
You can set the information display to ask you each time which level of guard you wish to set.
Using the information display controls, scroll to:
Message
| Action and Description
|
---|
Settings | Press the OK button.
|
Vehicle settings
| Press the OK button.
|
Alarm | Press the OK button.
|
Ask on exit | Press the OK button.
|
Reduced guard
| Appears in the information display each time you switch your vehicle off.
If you wish to arm the alarm with reduced guard, press the OK button when this message appears.
If you wish to arm the alarm with full guard, leave your vehicle without pressing the OK button.
|
Note:
Selecting reduced guard does not set the alarm permanently to reduced guard. It sets it to reduced guard only for the current locking cycle.
Arming the Alarm
Disarming the Alarm
Vehicles Without Keyless Entry
Disarm and silence the alarm by unlocking the doors with the key and switching your vehicle on with a correctly coded key or unlocking the doors with the remote control.
Vehicles with Keyless Entry
Note:
A valid passive key must be located within the detection range of that door for keyless entry. See
Keyless Entry.
Disarm and silence the alarm by unlocking the doors and switching your vehicle on or unlocking the doors with the remote control.