Wet or winter driving conditions with ice, snow or salty road mist can cause inconsistent and unexpected wiping or smearing.
Missing Image
AAutowipers On.
BHigh sensitivity.
CLow sensitivity.
Missing Image  Use the rotary control to adjust the sensitivity of the autowipers.
When you select low sensitivity, the wipers operate when the sensor detects a large amount of water on the windshield. When you select high sensitivity, the wipers operate when the sensor detects a small amount of water on the windshield.
 Keep the outside of the windshield clean. The rain sensor is very sensitive and the wipers may operate if dirt, mist or insects hit the windshield.
In these conditions, you can do the following:
  • Lower the sensitivity of the autowipers to reduce the amount of smearing on the windshield.
  • Switch to normal or high-speed wipe.
  • Switch autowipers off.
Note:   Fully defrost the windshield before you switch the windshield wipers on.
Note:   Make sure that you switch the windshield wipers off before entering a car wash.
Note:   If streaks or smears appear on the windshield, clean the windshield and the wiper blades.If that does not resolve the issue, install new wiper blades.
Note:   If you switch autolamps and autowipers on, the headlamps turn on when the windshield wipers continuously operate.
Autowipers Settings
This setting defaults to on and remains on until you switch it off in the information display.
When you switch off autowipers, the wipers operate in intermittent mode.
Low Temperature Wipe Inhibit
The rain sensing feature will not operate immediately after starting your vehicle when it is in park (P) and the outside temperature is below 32°F (°C). You can switch on the wipers by adjusting the rain sensor sensitivity or adjusting the wiper speed.
This prevents damage to the wiper blades from ice and snow on the windshield.