Vertical Aim Adjustment
The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been in an accident, have the alignment of your headlamps checked by your authorized dealer.
Headlamp Aiming Target
Missing Image
A8 feet (2.4 meters)
BCenter height of lamp to ground
C25 feet (7.6 meters)
DHorizontal reference line
Vertical Aim Adjustment
  1. Park the vehicle directly in front of a wall or screen on a level surface, approximately 25 ft (7.6 m) away.
  1. Measure the height from the center of your headlamp indicated by a 3.0 millimeter circle on the lens to the ground and mark an 8 ft (2.4 m) horizontal reference line on the vertical wall or screen at this height (a piece of masking tape works well).
Note:   To see a clearer light pattern for adjusting, you may want to block the light from one headlamp while adjusting the other.
  1. Turn on the low beam headlamps to illuminate the wall or screen and open the hood. Cover one of the headlamps so no light hits the wall.
Missing Image
  1. There is a distinct cut-off (change from light to dark) in the left portion of the beam pattern. Position the top edge of this cut-off 2 in (5 cm) below the horizontal reference line.
Missing Image
  1. Locate the vertical adjuster on each headlamp.Use a Phillips #2 screwdriver to turn the adjuster either clockwise or counterclockwise to adjust the vertical aim of the headlamp.The horizontal edge of the brighter light should touch the horizontal reference line.
  1. Repeat Steps 3 through 7 to adjust the other headlamp.
  1. Close the hood and turn off the lamps.
Horizontal Aim Adjustment
Horizontal aim is not required for this vehicle and is not adjustable.