Note:   The system is not compatible with non-Ford aftermarket remote start systems.Use of these systems may result in vehicle starting problems and a loss of security protection.
Note:   Metallic objects, electronic devices or a second coded key on the same key chain may result in vehicle starting problems, especially if they are too close to the key when starting your vehicle.Prevent these objects from touching the coded key when starting your vehicle.If your vehicle fails to start, switch your vehicle off, move all objects on the key chain away from the key and start your vehicle.
Note:   Do not leave a duplicate coded key in your vehicle.Always take your keys and lock all doors when leaving your vehicle.
SecuriLock
The system helps prevent your vehicle from starting unless you use a coded key programmed to your vehicle. A message may appear in the information display.
If your vehicle fails to start, the system may have a fault. Contact an authorized dealer. A message may appear in the information display.
Automatic Arming
The system arms when you switch your vehicle off.
Automatic Disarming
The system disarms when you switch your vehicle on with a coded key.
Replacement Keys
Note:   Your vehicle comes with two keys.
The intelligent access key functions as a programmed key that operates the driver door lock and turns on the intelligent access with push button start system, as well as a remote control.
If your intelligent access keys are lost or stolen and you do not have an extra coded key, you need to have your vehicle towed to an authorized dealer. You need to erase the key codes from your vehicle and program new coded keys.
Store a spare intelligent access key away from your vehicle in a safe place. Contact an authorized dealer to purchase additional spare or replacement keys.
Programming a Spare Intelligent Access Key
You must have two previously programmed coded keys and the new unprogrammed key readily accessible. Contact an authorized dealer to have the spare key programmed if two previously programmed keys are not available.
Make sure that your vehicle is switched off before beginning this procedure. Make sure that you close all the doors before beginning and that they remain closed throughout the procedure. Carry out all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you carry out any steps out of sequence.
Note:   You can program a maximum of eight coded keys to your vehicle.
Read and understand the entire procedure before you begin.
Center Console Tray Removal
  1. Open the floor console storage compartment lid.
  1. Remove the tray.
Intelligent Access Key Backup Slot
  1. Place the first programmed intelligent access key flat on the symbol at the bottom of the floor console storage compartment.
  1. Press the START STOP button.
  1. Wait five seconds and then press the START STOP button again.
  1. Remove the intelligent access key.
  1. Within 10 seconds, place a second programmed intelligent access key flat on the symbol.
  1. Press the START STOP button.
  1. Wait five seconds and then press the START STOP button again.
  1. Remove the intelligent access key.
  1. Within 10 seconds, place the unprogrammed intelligent access key flat on the symbol.
  1. Press the START STOP button.
 Programming is now complete. Check that the remote control functions operate and your vehicle starts with the new intelligent access key.
If programming was unsuccessful, wait 10 seconds and repeat Steps 1 through 12. If programming remains unsuccessful, have your vehicle checked by an authorized dealer.

Owner's Manual Feedback

Submit

Thank You For Your Feedback

Ok