WARNING:
Do not use cruise control on winding roads, in heavy traffic or when the road surface is slippery. This could result in loss of vehicle control, serious injury or death.
WARNING:
When you are going downhill, your vehicle speed may increase above the set speed. The system will not apply the brakes but a warning displays. Failure to follow this warning could result in serious personal injury or death. |
The cruise controls are on the steering wheel.
Note:
Cruise control will disengage if your vehicle speed decreases more than
16 km/h (10 mph) below your set speed while driving uphill.
Switching Cruise Control On and Off
Press the button to set the Cruise Control in standby mode. The information display will prompt you to set a speed. Press the button again to turn the system off.
Setting the Cruise Speed
- Drive to desired speed.
- Press and release SET+.
- Take your foot off the accelerator pedal.
The indicator displays in the instrument cluster. | |
Changing the Set Speed
- Press and release SET+ or SET-. When you select km/h as the display measurement in the Information display the set speed changes in approximately 1 km/h increments. When you select mph as the display measurement in the information display the set speed changes in approximately 1 mph increments.
- Press the accelerator or brake pedal until you reach the desired speed. Press and release SET+.
- Press and hold SET+ or SET-. Release the control when you reach the desired speed.
Canceling the Set Speed
Press and release CAN, or tap the brake pedal. The indicator no longer displays in the instrument cluster. The set speed will not be erased.
Note:
For vehicles with manual transmission, depressing the clutch pedal will also cancel the set speed.
Resuming the Set Speed
Press and release RES. The indicator displays in the instrument cluster.