AdvanceTrac® with Roll Stability Control™ (RSC®)
The system turns on each time you switch the ignition on.
You can switch the electronic stability control and roll stability control portions of the system off.
When you shift the transmission into reverse (R) the systems disable.
Use the traction and stability control switch on the instrument panel to switch the systems off or on.
You can independently switch off the traction control portion of the system.
AdvanceTrac with RSC Features
|
---|
Button functions
| Stability control light
| Roll stability control
| Electronic stability control
| Traction control system
|
Default at start-up
| Illuminated during bulb check
| Enabled
| Enabled
| Enabled
|
Button pressed momentarily
| Illuminated
| Enabled
| Enabled1
| Disabled
|
Button pressed and held for more than 5 seconds
| illuminated3
| Disabled
| Disabled
| Disabled
|
Double Press (Pickup Only)
| Illuminated
| Enabled
| Enabled 1
| Enabled2
|
Button pressed again after deactivation
| Not illuminated
| Enabled
| Enabled
| Enabled
|
Transfer case switched to 4WD Low 4
| Illuminated
| Disabled
| Disabled
| Disabled
|
1Electronic stability control has reduced sensitivity compared to a fully active system.
2Traction control has reduced sensitivity compared to a fully active system.
3Lamp light starts blinking for four seconds after entering the press and hold state.
4Engaging 4WD Low disables roll stability control, electronic stability control and the traction control systems.