This view of the Owner’s Manual contains the very latest information, which may vary slightly from the printed Owner’s Manual originally provided with your vehicle. It may also describe content that is not on or operates differently on your vehicle. Please consider the Owner’s Manual originally provided with your vehicle as the primary source of information for your vehicle.
The information contained in this publication was correct at the time of release.In the interest of continuous development, we reserve the right to change specifications, design or equipment at any time without notice or obligation.No part of this publication may be reproduced, transmitted, stored in a retrieval system or translated into any language in any form by any means without our written permission.Errors and omissions excepted.
Copyright © 2024 Ford Motor Company
Engine Oil Check
To check the engine oil level consistently and accurately, do the following:
- Make sure the parking brake is on. Make sure the transmission is in park (P) or neutral (N).
- Run the engine until it reaches normal operating temperature.
- Make sure that your vehicle is on level ground.
- Switch the engine off and wait 15 minutes for the oil to drain into the oil pan.Checking the engine oil level too soon after you switch the engine off may result in an inaccurate reading.
- Open the hood. See Opening and Closing the Hood.
- Remove the dipstick and wipe it with a clean, lint-free cloth. See Under Hood Overview.
- Replace the dipstick and remove it again to check the oil level. See Engine Oil Dipstick.
- Make sure that the oil level is between the maximum and minimum marks. If the oil level is at the minimum mark, add oil immediately. See Capacities and Specifications.
- If the oil level is correct, replace the dipstick and make sure it is fully seated.
Note:
Do not remove the dipstick when the engine is running.
Note:
If the oil level is between the maximum and minimum marks, the oil level is acceptable.Do not add oil.
Note:
The oil consumption of new engines reaches its normal level after approximately
3,100 mi (5,000 km).
Adding Engine Oil
WARNING:
Do not remove the filler cap when the engine is running. |
Do not use supplemental engine oil additives because they are unnecessary and could lead to engine damage that may not be covered by the vehicle Warranty.
Only use oils certified for gasoline engines by the American Petroleum Institute (API). An oil with this trademark symbol conforms to the current engine and emission system protection standards and fuel economy requirements of the International Lubricants Specification Advisory Committee (ILSAC).
To top up the engine oil level do the following:
- Clean the area surrounding the engine oil filler cap before you remove it.
- Remove the engine oil filler cap. See Under Hood Overview. Turn it counterclockwise and remove it.
- Add engine oil that meets Ford specifications. See Capacities and Specifications. You may have to use a funnel to pour the engine oil into the opening.
- Recheck the oil level.
- If the oil level is correct, replace the dipstick and make sure it is fully seated.
- Replace the engine oil filler cap.Turn it clockwise until you feel a strong resistance.
Note:
Do not add oil further than the maximum mark.Oil levels above the maximum mark may cause engine damage.
Note:
Make sure you install the oil filler cap correctly.
Note:
Soak up any spillage with an absorbent cloth immediately.
Thank You For Your Feedback