This view of the Owner's Manual contains the very latest information, which may vary slightly from the printed Owner's Manual originally provided with your vehicle. It may also describe content that is not on or operates differently on your vehicle. Please consider the Owner's Manual originally provided with your vehicle as the primary source of information for your vehicle.
The information contained in this publication was correct at the time of release.In the interest of continuous development, we reserve the right to change specifications, design or equipment at any time without notice or obligation.No part of this publication may be reproduced, transmitted, stored in a retrieval system or translated into any language in any form by any means without our written permission.Errors and omissions excepted.
Copyright © 2024 Ford Motor Company
Remote Control - Vehicles Without: Passive Anti-Theft System (PATS)
Press the button on the remote control to switch the panic alarm on.Press the button again or switch the ignition on to switch the panic alarm off.
Integrated Keyhead Transmitter (If Equipped)
Use the key blade to start your vehicle and unlock or lock the driver door from outside your vehicle.
Note:
Your vehicle keys came with a security label that provides important key cut information.Keep the label in a safe place for future reference.
Programming a New Remote Control
Read and understand the entire procedure before you begin.
Make sure all new and existing remote controls are present before beginning this procedure. This procedure erases all existing programmed remote controls. Reprogram all the existing remote controls during this procedure.
- Unlock the vehicle with the power door unlock control.
- Switch the ignition from off to on eight times within six seconds, finishing in the off position. A tone sounds to indicate that it is now possible to program a remote control.
- Press and hold any button on the remote control within 10 seconds. A tone sounds as confirmation.
- Repeat step 3 within 10 seconds for each remote control.
Note:
Programming ends when you switch the ignition on, or after 10 seconds.
If you have successfully programmed the remote control, it operates the remote entry system.
If programming was unsuccessful, wait 10 seconds and repeat the process.
Note:
You can program a maximum of eight remote controls to your vehicle.
Changing the Remote Control Battery
The remote control uses one coin-type three-volt lithium battery CR2032 or equivalent.
Note:
Refer to local regulations when disposing of remote control batteries.
Note:
Do not wipe off any grease on the battery terminals or on the back surface of the circuit board.
Note:
Replacing the battery does not erase the programmed remote control from your vehicle.The remote control should operate normally.
Integrated Keyhead Transmitter
- Twist a thin coin in the slot of the transmitter near the key ring to remove the battery cover.
- Remove the old battery.
- Insert the new battery.Refer to the instructions inside the transmitter for the correct orientation of the battery.Press the battery down to make sure it is fully in the housing.
- Reinstall the battery housing cover onto the transmitter.
Locating Your Vehicle
Press the lock button on the remote control twice within three seconds. The horn sounds and the direction indicators flash.
Note:
If locking was not successful, any door is open, or if the hood is open on vehicles with an alarm or remote start then the horn sounds but the direction indicators do not flash.
Switching the Panic Alarm On and Off
Press the button on the remote control to switch the panic alarm on.Press the button again or switch the ignition on to switch the panic alarm off.We recommend you do not use this method to locate your vehicle.
Note:
The panic alarm only operates when the ignition is off.
Thank You For Your Feedback