Removing the Roof Rack (If Equipped)
- Using the provided T30 tool, remove the front roof rack cover fasteners.
- Remove the front roof rack covers by pulling upward at the rear edge and rotating forward.
- Using the provided T30 tool, remove the front roof rack fasteners.
- Remove the cover to access the rear fastener.
- Using the supplied special tool, loosen the fastener until you can remove the rack.
- Remove the rack from the vehicle.
Note:
The windshield trim cover, retaining plate and fasteners are provided. The trim cover is installed when you remove the roof rack.
- Locate the trim cover components.
- Place the trim cover retaining plate over the mounting studs.
- Install the supplied fasteners. Torque nuts to
7.7 lb.ft (10.5 Nm).
- Align the cover with the alignment slot at the front of the cover, then rotate rearward and snap into place.
Installing the Roof Rack
- To remove, press the button on the rear of the cover and rotate forward.
- Remove the fasteners and remove the trim cover retaining plate.
- Store the trim cover components.
- Position the roof rack on the vehicle.
- Hand start the front roof rack fasteners.
- Using the provided T30 tool, tighten the front roof rack fasteners. Torque bolts to
7.7 lb.ft (10.5 Nm).
- Align the cover with the alignment slot and rotate rearward.
- Hand start the front roof rack cover fasteners.
- Using the provided T30 tool, tighten the front roof rack cover fasteners. Torque bolts to
5.9 lb.ft (8 Nm).
Note:
The rear crossbar is part of the clamping system. If you removed the crossbar you must install it first for proper attachment to the hard top.
- Using the supplied special tool, tighten the fastener.
Note:
The supplied special tool stops turning the fastener when you have proper torque applied.
- Install the rear roof rack fastener cover.