WARNING:
Do not leave the kit unattended when it is in use. Failure to follow this instruction could result in personal injury or death.
WARNING:
Check the sidewall of the tire prior to inflation. If there are any cracks, bumps or similar damage, do not attempt to inflate the tire. This could cause personal injury. |
- Check for a punctured tire.
Note:
Do not remove objects, for example nails or screws from a punctured tire.

- To temporarily repair a punctured tire, release the tire inflation pipe and the 12-volt DC power point connector from the underside of the compressor.

- Turn the sealant bottle access cap counterclockwise and remove it.

- Remove the sealant bottle cap. Do not pierce or remove the seal.

- Attach the sealant bottle to the compressor. Turn the sealant bottle clockwise until you feel a strong resistance.
Note:
Attaching the sealant bottle to the compressor pierces the seal. Do not loosen the bottle as sealant could escape.

- Remove the tire valve dust cap and attach the tire inflation pipe.

- Plug the 12-volt DC power point connector into the 12-volt DC socket. See
Power Outlet.
- Start the engine.

WARNING:
Do not stand directly beside the tire while the compressor is operating. This could cause personal injury if the tire bursts. |
- Switch the compressor on.

WARNING:
Watch the sidewall of the tire when inflating. If any cracks, bumps or similar damage appears, switch the compressor off and let the air out by means of the pressure relief valve. Do not continue driving with this tire. This could cause loss of vehicle control.
WARNING:
Do not keep the compressor operating for more than 10 minutes. This could cause the compressor to malfunction causing serious personal injury. |
- Inflate the tire to between
2–3 bar (29–44 psi) as shown on the Tire Label on the B pillar.See
Tire Pressure Specifications - 1.0L EcoBoost (70kW/95PS) (M0)/1.0L EcoBoost (92kW/125PS) (B7)/1.0L EcoBoost (114kW/155PS) (BZ)/1.0L EcoBoost (118kW/160PS) (Q0), ST Line/ST Line X/Titanium, Mild Hybrid Electric Vehicle (MHEV), Excluding: ST
.
See
Tire Pressure Specifications - Electric Motor (C0), Battery Electric Vehicle, Excluding: ST
.
See
Tire Pressure Specifications - ST.
Note:
If the tire pressure does not reach
1.8 bar (26 psi) within 10 minutes, the tire could be damaged beyond a temporary repair. Have your vehicle immediately checked. Do not drive your vehicle.
- When the tire reaches the recommended tire pressure of between
2–3 bar (29–44 psi), switch the compressor and the ignition off. See
Tire Pressure Specifications - 1.0L EcoBoost (70kW/95PS) (M0)/1.0L EcoBoost (92kW/125PS) (B7)/1.0L EcoBoost (114kW/155PS) (BZ)/1.0L EcoBoost (118kW/160PS) (Q0), ST Line/ST Line X/Titanium, Mild Hybrid Electric Vehicle (MHEV), Excluding: ST
.
See
Tire Pressure Specifications - Electric Motor (C0), Battery Electric Vehicle, Excluding: ST
.
See
Tire Pressure Specifications - ST.
- Disconnect the tire inflation pipe and the 12-volt DC power point connector.
Note:
Do not remove the sealant bottle from the compressor.
- Reinstall the tire valve dust cap.
- Place the warning label on the steering wheel and correctly stow the kit.

- Immediately drive your vehicle for
3–10 km (2–6 mi). Do not exceed
80 km/h (50 mph).

- After driving between
3–10 km (2–6 mi), stop your vehicle and recheck the tire pressure. See
Tire Pressure Specifications - 1.0L EcoBoost (70kW/95PS) (M0)/1.0L EcoBoost (92kW/125PS) (B7)/1.0L EcoBoost (114kW/155PS) (BZ)/1.0L EcoBoost (118kW/160PS) (Q0), ST Line/ST Line X/Titanium, Mild Hybrid Electric Vehicle (MHEV), Excluding: ST
.
See
Tire Pressure Specifications - Electric Motor (C0), Battery Electric Vehicle, Excluding: ST
.
See
Tire Pressure Specifications - ST.
Note:
If the tire pressure has dropped to
1.8 bar (26.1 psi) or below, the tire could be damaged beyond a temporary repair. Have your vehicle immediately checked. Do not drive your vehicle.
Note:
If the tire pressure has dropped but is still above
1.8 bar (26 psi), use the kit to inflate the tire again.
After Using the Tire Sealant and Inflator Kit
WARNING:
If you experience any unusual vibration, ride disturbance or noise while driving, reduce your speed until you can safely pull off to the side of the road and call for roadside assistance. Failure to do so could cause you to lose control of your vehicle and increase the risk of personal injury or death. |
The kit only provides temporary mobility. Regulations concerning tire repair or replacement after using the kit could differ from country to country. We recommend you consult a tire specialist.
After using the kit:
- Do not drive your vehicle more than
200 km (124 mi) before repairing or replacing the punctured tire.
- Inform all other users of your vehicle that a tire was sealed using the kit. Make them aware of the special driving conditions that must be observed.
- Regularly check the tire pressure until the sealed tire is repaired or replaced by a tire specialist. Before the tire is removed from the rim, you must inform the tire specialist that the tire contains sealant.
- Take the kit to an authorized dealer to have the sealant bottle and the tire inflation pipe replaced.