The information contained in this publication was correct at the time of release.In the interest of continuous development, we reserve the right to change specifications, design or equipment at any time without notice or obligation.No part of this publication may be reproduced, transmitted, stored in a retrieval system or translated into any language in any form by any means without our written permission.Errors and omissions excepted.
Copyright © 2023 Ford Motor Company
Engine Oil Check
- Make sure that your vehicle is on level ground.
- Switch off the engine and wait 10 minutes for the oil to drain into the oil pan.
- Remove the dipstick and wipe it with a clean, lint free cloth. Reinstall the dipstick and remove it again to check the oil level.
If the oil level is at the minimum mark, add oil immediately. See
Capacities and Specifications - 2.0L Diesel.
Note:
Check the oil level before starting the engine.
Note:
Make sure that the oil level is between the minimum and the maximum marks.
Note:
Do not use oil additives or other engine treatments. Under certain conditions, they may damage the engine.
Note:
The oil consumption of new engines reaches its normal level after approximately
5,000 km.
Adding Oil
WARNING:
Do not add engine oil when the engine is hot. Failure to follow this instruction could result in personal injury.
WARNING:
Do not remove the filler cap when the engine is running. |
- Remove the filler cap.
- Add oil that meets Ford specifications. See Capacities and Specifications - 2.0L Diesel.
- Replace the filler cap. Turn it until you feel a strong resistance.
Note:
Do not add oil further than the maximum mark.Oil levels above the maximum mark may cause engine damage.
Note:
Soak up any spillage with an absorbent cloth immediately.