Programming a Personal Entry Code
- Enter the five-digit master code.
- Press 1·2 on the keypad within five seconds.
- Enter your personal five-digit code.You must do this within five seconds of completing Step 2.
- Press 1·2 on the keypad to save personal code 1.
The doors lock then unlock to confirm that programming was successful.
To program additional personal entry codes, repeat Steps 1 through 3, then for Step 4:
- Press 3·4 to save personal code 2.
- Press 5·6 to save personal code 3.
- Press 7·8 to save personal code 4.
- Press 9·0 to save personal code 5.
If your vehicle comes with the operating system, you can also program the system with one personal entry code.
Note:
Programming a code using the operating system overwrites any code that was already saved on the position 9·0 of the Keypad.
Hints:
- Do not set a code that uses five of the same number.
- Do not use five numbers in sequential order.
- The five-digit master code works even if you have set your own personal code.
Erasing a Personal Code
- Enter the five-digit master code.
- Press and release 1·2 on the keypad within five seconds.
- Press and hold 1·2 for two seconds. You must do this within five seconds of completing Step 2.
All personal codes erase and only the five-digit master code works.
Anti-Scan Feature
The keypad goes into an anti-scan mode if you enter the wrong code seven times. This mode turns off the keypad for one minute and the keypad lamp flashes.
The anti-scan feature turns off after:
- One minute of keypad inactivity.
- You press the unlock button on the remote control.
- You switch the ignition on.
- You unlock your vehicle using keyless entry.