Exterior Bulbs - Changing a Headlamp Bulb

This view of the Owner's Manual contains the very latest information, which may vary slightly from the printed Owner's Manual originally provided with your vehicle. It may also describe content that is not on or operates differently on your vehicle. Please consider the Owner's Manual originally provided with your vehicle as the primary source of information for your vehicle.

The information contained in this publication was correct at the time of release.In the interest of continuous development, we reserve the right to change specifications, design or equipment at any time without notice or obligation.No part of this publication may be reproduced, transmitted, stored in a retrieval system or translated into any language in any form by any means without our written permission.Errors and omissions excepted.

Changing a Headlamp Bulb

WARNING: Make sure the bulbs have cooled down before removing them. Failure to follow this warning could result in serious personal injury.

Accessing the Halogen High Beam and Low Beam Bulbs

Rotate the steering wheel to the opposite side of the bulb needing replacement.

Remove the screws and push pins from the front of the wheel liner.

Pull the wheel liner back towards the tire to gain access to the bulbs.

Replacing the Halogen High Beam and Low Beam Bulbs

Low beam headlamp bulb.
B.

Turn signal lamp bulb.
C.

High beam headlamp bulb.

Replacing the Halogen High Beam, Low Beam and Direction Indicator Bulbs

Make sure the headlamps are off.

For the high beam and low beam bulbs, remove the rubber cap to access the bulbs.

Remove the bulb holder from the lamp assembly by turning it counterclockwise and pulling it straight out.

Disconnect the bulb from the electrical connector.

To install, reverse the removal procedure.

Note: Handle a halogen headlamp bulb carefully and keep out of children’s reach. Grasp the bulb only by its plastic base and do not touch the glass. The oil from your hand could cause the bulb to break the next time the headlamps are operated.

Note: If the bulb is accidentally touched, clean it with rubbing alcohol before installing it.

Owner's Manual Feedback

Submit

Thank You For Your Feedback