Place the sticker in an area visible by the rear view camera. The entire sticker must be within 4–19 in (10–48 cm) from the center of the hitch ball, as shown in the following illustration.
Image Shown Without Description
Use the supplied sticker placement card, a tape measure and pen to carefully mark the area to attach the sticker. Make sure the entire sticker is within the green zone between the two arcs or distance markers on the diagram, and is also visible in the rear view camera display.
Once you have found the correct location, place the sticker.
Note:   Make sure nothing can obstruct the rear view camera's view of the sticker such as a jack handle or wiring.
Note:   Position the sticker on a flat, dry and clean horizontal surface. For best results, apply the sticker when temperatures are above 32 °F (0 °C).
Note:   Do not move stickers after placing them. Do not re-use any stickers if removed.
Note:   You can purchase additional stickers through your authorized dealer.
Note:   If you previously setup the trailer with the trailer sensor, make sure it is not plugged in before configuring the trailer and placing the sticker.

Owner's Manual Feedback

Submit

Thank You For Your Feedback

Ok