Activating the Manual Park Release Cable
- Apply the parking brake.
Note:
If the battery has run out of charge, use an external power source to apply the parking brake.
- Remove the access cover located within the center console using a plastic wedge or pry tool.
Note:
Do not pull the tether.
- Sit in the driver seat.
- Power your vehicle on without your foot on the brake pedal.
Note:
Do not attempt this procedure when the engine is running. Failure to follow this instruction could result in vehicle damage not covered by the vehicle warranty.
- Press and hold the brake pedal.
- Pull the tether towards you until the lever engages.
Note:
There is an audible click when it engages
Note:
Do not use excessive force. Failure to follow this instruction could result in vehicle damage not covered by the vehicle warranty.
Note:
A message appears when your vehicle is out of park (P). If you do not receive a message attempt the procedure again.
- Release the parking brake.
- Switch your vehicle off.
- Release the brake pedal.
Note:
Your vehicle is free to roll.
- Disconnect the negative battery cable from the battery as soon as it is safe to do so.
Note:
If your vehicle detects wheel speed when the battery is connected, the electronic parking brake could apply.
Returning Your Vehicle to Normal Mode
- Connect the negative battery cable to the battery as soon as it is safe to do so.
Note:
If your vehicle detects wheel speed when the battery is connected, the electronic parking brake could apply.
- Apply the parking brake.
Note:
: If the battery has run out of charge, use an external power source to apply the parking brake.
- Sit in the driver seat.
- Press and hold the brake pedal
Note:
Do not start your vehicle.
- Press the white button. The lever returns to stowed position.
- Start your vehicle.
- Confirm the instrument cluster displays park (P).
Note:
If the instrument cluster does not display park (P) or if Park Not Available, Transmission Not In Park or Shift System Fault message persists, contact an authorized dealer for service.
- Switch your vehicle off.
- Release the brake pedal.
- Install the access cover.